Slacken the lockouts (A), then unscrew the linkage rod (B)

A Unscrew the two bolts (arrowed) and displace the bracket...

B... to access the holder bolt (arrowed)

it from the lever and the arm (the rod is reverse-threaded on one end and so will simultaneously unscrew from both lever and arm when turned in the one direction) (see illustration). Note the how far the rod is threaded into the lever and arm as this determines the height of the lever relative to the footrest.

11 The lever pivots on the footrest holder. Unscrew the two bolts securing the footrest bracket to the frame and turn it round to access the holder bolt (see illustrations). Unscrew the bolt and remove the footrest and its holder. Remove the wave washer and slide the lever off the holder.

Unhook the spring (A), then unscrew the nut (B) and remove the bolt

Installation

12 Installation is the reverse of removal, noting the following:

a) Apply molybdenum bisulphide grease to the gear lever pivot.

b) Align the flat on the footrest holder with that in the bracket. Do not forget the wave washer.

c) Apply a suitable non-permanent thread locking compound to the footrest holder bolt and tighten it to the torque setting specified at the beginning of the Chapter.

d) Adjust the gear lever height as required by screwing the rod in or out of the lever and arm. Tighten the locknuts securely (see illustration 3.10).

Sidestand -

I

removal and installation

1 The sidestand is attached to a bracket on the frame. A spring anchored to the stand ensures that it is held in the retracted or extended position.

2 Support the bike using an auxiliary stand. On L, N and R models, remove the sidestand switch (see Chapter 9).

3 Unhook the stand spring and unscrew the nut securing the stand on the pivot bolt (see

illustration). Remove the pivot bolt from the inside of the bracket and remove the stand. and on J and К models the thrust washers.

4 If required, unscrew the bolts securing the sidestand bracket to the frame and remove the bracket.

5 On installation apply grease to the pivot bolt shank and tighten the nut securely. Reconnect the sidestand spring and check that it holds the stand securely up when not in use - an accident is almost certain to occur if the stand extends while the maciine is in motion.

6 On L, N and R models, check the operation of the sidestand switch (see Chapter 1).

5 Handlebars and levers -

I

removal and installation

Right-hand handlebar

Removal

1 Disconnect the brake light switch wires from the switch on the underside of the master cylinder assembly. Unscrew the two handlebar switch screws and free the switch from the handlebar (see illustration). Unscrew the two tirottle cable housing screws and release trie throttle cables from the throttle pulley (see illustration). Position

Дата добавления: 2015-10-29