Nut is clear of its lug, then slip the cable

out of the bracket...

4 Now unscrew the lower (decelerator) cable holder until the captive nut is free, then slip the holder out of the bracket and detach the cable nipple from the cam (see illustrations). Withdraw the cables from the machine noting the correct routing of each cable.

5 Unscrew the lower (decelerator) cable elbow nut at the throttle pulley housing and slacken the upper (accelerator) cable locknut (see illustration). Remove the housing screws and draw off the rear half (see illustration). Detach the cable nipples from the pulley, then detach the front housing half from the handlebar and withdraw the lower elbow and cable from the housing (see illustrations) Thread the housing off the upper elbow and withdraw the cable from the housing (see illustration). Mark each cable to ensure it is connected correctly on installation.

Installation

6 Fit the accelerator cable elbow into the
upper socket of the front half of the throttle
pulley housing and thread the housing onto it
(see illustration). Lubricate the cable nipple
with multi-purpose grease and install it into
the throttle pulley (see illustration). Fit the
decelerator cable into the lower socket and
tighten the nut. then lubricate the cable nipple
with multi-purpose grease and install it into
the pulley (see Illustration and 11.5c). Fit the
front half of the housing over the pulley and
onto the handlebar.

11.4b... and the cable end out of the cam

	b®

11.5d...and draw the lower cable out

B Remove the screws (A) and the rear half of the housing (B)

A Unscrew the lower nut (A), and

Slacken the upper nut (B). Cable adjuster

Locknut (C) and adjuster (D)

C Detach the cable ends...

11.Se Thread the housing off the upper cable nut

A Thread the housing onto the upper cable nut...

B... then fit the cable end into the pulley

C Thread the lower cable nut into the housing

4*14 Fuel and exhaust systems

Locate the pin (arrowed) into the hole in the handlebar

Дата добавления: 2015-10-29