Tighten the drain plug securely

Every 4000 miles (6000 km) or 6 months

i«ii

environmental agency to see whether they will accept the used oil tor recycling. Don't pour used oil into drains or onto the ground.

BWWjg!! Check the old oil carefully -''■I"' ■' if it is very metallic coloured. HiNT

then the engine is experiencing wear from break-in (new engine) or from insufficient lubrication. If there are flakes or chips of metal in the oil, then something is drastically wrong internally and the engine will have to be disassembled for inspection and repair. If there are pieces of fibre-like material in the oil, the clutch is experiencing excessive wear and should be checked.

8.2 On L, N and R models, slacken the clamp screws (arrowed)

0800 66 33 66

Note: It is antisocial and illegal to dump oil down the drain. To find the location of your local oil recycling bank, call this number free.

Caution: If the machine is continually ridden in continuously wet or dusty

8.3a Air filter cover screws (arrowed) -J and К models

conditions, the filter should be renewed more frequently.

1 Remove the fuel tank (see Chapter 4).

2 On L. N and R models, slacken the clamps securing the inlets on the air filter cover to the air ducts (see illustration).

3 Remove the screws securing the air filter cover to the filter housing and remove the cover (see illustrations). Remove the filter element from the housing (see illustrations).

4 To clean the filter, tap the element on а hard surface to dislodge any dirt and use compressed air to clear the element, directing the air from the inside (see illustration).

5 Check the element for signs of damage. If the element is torn or cannot be cleaned, renew it.

6 Remove the sub-air cleaner element from its housing (mounted on the back of the air filter housing), and clean or renew it as required.

7 Install the new filter by reversing the removal procedure (see illustrations 8.3c and d). Make sure the filter is properly seated, then install the cover. On L, N and R models. make sure the inlets locate correctly onto the air ducts and tighten the clamps (see illustration).

8 Install the fuel tank (see Chapter 4).

Дата добавления: 2015-10-29