Basic Broadcast

The method which was taught to me is the basic method of broadcasting. Use the analysis board and pendu­lum to determine the problem and what product is needed for correction, then follow the steps for utilizing the basic method to broadcast.

1. Use the chart or picture which shows the area where the problem is (brain, arteries, kidney, etc.).

2. On that picture place the identification of the per­son having the problem - either the person's picture, blood sample, hair, or piece of paper on which is written the full name of the person, address, and birthdate. Place the identi­fication face down and very close to where the problem is (not over exact spot).

3. Place a container to hold the product to be broad­cast on the area of the chart to receive the broadcast. Re­member, the product will correct only what the container covers, so choose the proper size container for this broad­cast The product should be put into the container, using the pendulum to determine the proper amount. Start the pendu­lum in a reverse motion as the product is poured into the container. When enough is in the container to cancel the vi­brations (nullify the problem), the pendulum will change motions and swing clockwise (positive) indicating there is now enough of the product in the container to make the correction.

44 PENDULUM AND PROJECTIONS

Place the product, the identification (face down) and the magnet on the white surface of the beamer. None of these items need to touch each other.

All this part copper coils.

1. Remove protection 2. Place on beamer

Figure 4. Beamer used for projection or broadcasting.

PROJECTION 45

4. Certain colors help give the projection power. To find the color (or more than one) that would benefit the per­son for this broadcast, use the witness area on the board with identification, then with the pointer, go down the chart of colors and wait each time for the pendulum to give the answer. Neutralize the colors by tapping two pieces to­gether to clear vibrations. Place the color (or more than one) on top of the product in the container. Put magnet on top of glass.

This is the setup for the basic broadcast or projec­tion for specific areas of the body.

Projections take different lengths of time for the
body to make the correction. One may take only a matter of
two or three minutes-some projections may take 15 or 20
minutes or even longer. For instance, a projection that is
used for dissolving gallstones may take from 8 to 12 hours,
and on some occasions may go even longer. Time varies
from one projection to another. Always check with the pen­
dulum for the time needed for each broadcast, and perhaps
make a written note beside the broadcast with the time jot­
ted down when the broadcast will be completed.__________ -

Alignment Unit

Another projector we now have is a little broad­caster used for aligning the spine, aligning the skull, straightening out the ribs, putting the ribs back in where they are supposed to be if they are out of alignment, and so on. We use an activator with a plunger to give it the effect of tapping the spine. We have a chart with a picture of the spine. You take the plunger, holding it perpendicular to the chart at the top of the spine (back of the head), push the plunger down until it releases. For some areas, you may

46 PENDULUM AND PROJECTIONS

Picture of plunger is actual size. Chart is approx­imately 8 x 16 inches.

have to hit the vertebrae two or three times with the plunger (always check with the pendu­lum for correct number of times). Some chiro­practors have a very hard time adjusting cer­tain portions of the body. In fact, many of them don't get the entire spine adjusted to perfect alignment. But this little unit, almost without fail, aligns the spinal column as it should be aligned.

People are truly amazed when their spine, which has been hurting them, stops hurt­ing. They can turn then-head up and down, and back and forth. Distance makes no difference. Your mind can carry this projection anywhere in the world. We find this to be a very fasci­nating piece of equip­ment for projecting and correcting people with

PROJECTION 47

spines out of adjustment.

Directions for using the alignment unit:

1. At the edge of the chart, place the identification of the person whose spine is to be adjusted. Put it face down next to the head.

2. Hold activator perpendicular to the chart Start at the base of the skull and trip the activator on each verte­brae. Align all of the spine. It only takes 30 seconds and won't do any harm if the back is not out.

Дата добавления: 2015-07-24