Connecting Pedals

The Nord Lead 2X has two pedal inputs, one for a sustain pedal and one for a control pedal (an expression-type pedal, used to control various parameters in much the same way as the modulation wheel). Connect the pedals as shown in the figure below:

• When connecting an expression-type pedal to the Control Pedal input, you should use a stereo cable (Tip-Ring-Sleeve). Please note that the pedal must have a stereo output jack. The resistance range of the Control Pedal should be 10 kOhm to 50 kOhm

• For information on how to set the Nord Lead 2X up for use with sustain or expression pedal, see page 19.

Подключение педалей

Nord Lead 2X имеет два входа педалей, для педали сустейна и для педали экспрессии (педаль экспрессии используется для управления разными параметрами так же, как колесо модуляции). Подключите педали, как показано на рисунке ниже:

• При подключении педали экспрессии к входу Control Pedal, используйте стерео кабель (TRS). Обратите внимание, что педаль должна иметь стерео разъем. Диапазон сопротивления педали управления должен быть 10кОм - 50кОм

• Информацию о настройке Nord Lead 2X для работы с педалями сустейна или экспрессии, см. на стр. 19.

BASIC OPERATION

Demo Play Function

Before you try out the new features for yourself, you may want to listen to what can be done with the instrument. The Nord Lead 2X is equipped with a built-in demo playback function. There are a number of demo songs in ROM, showing the instrument’s versatility and features in different contexts. To listen to the demo songs, do like this:

1. Simultaneously press the SHIFT and RING MOD/SYNC (Demo) buttons.

Playback starts. During playback, all knobs and buttons on the panel are disabled, except for MASTER LEVEL.

2. The demo songs are played back one after the other. If you want to move to the next or previous demo song, press the UP or DOWN button in the Program section of the panel.

3. To exit demo play mode, press any other button on the panel.

Basic MIDI Settings for the Nord Rack 2X

If you are using the Nord Rack 2X and controlling it from a MIDI keyboard, the Nord Rack 2X must be set to receive on the same MIDI channel that the keyboard transmits on. To get started, proceed as follows:

1. Set the master keyboard to transmit on MIDI Channel 1.

ОСНОВНЫЕ ОПЕРАЦИИ

Дата добавления: 2015-10-30