Читайте также:
|
|
Tons. These are typically old-fashioned, non-wood mills pending an
Upgrade or closure. Some of these mills do not even operate a chemical recovery
Unit, and therefore pollution caused by the bleaching process can unfortunately
Be labeled as minor compared to the total discharge of waste.
Currently, the extent of TCF bleaching remains static, though the process is
maintaining its niche market position at around 5% of pulp production. TCF
Bleaching remains the method of choice for sulfite mills, though the slow
Decrease in sulfite operations and the continuing construction of new pulp mills
Using ECF bleaching will in time lead to a fall in the share of TCF bleaching.
In developed countries, kraft pulp mills began to use biodegradation plants for
Effluent treatment at an early stage. These included the use of large lagoons with
Aerators and anaerobic decomposition zones, while activated sludge systems were
Less common. The chemical oxygen demand (COD) or total organic carbon (TOC)
Are decreased by bacteria which consume the organic material. Today, rather narrow
Limits are set for COD and BOD (biochemical oxygen demand). The AOX are
removed in these plants predominantly by adsorption [11], and not by actual biodegradation.
Compared with the pollution levels of the early pulping operations – and also
compared to the situation just 10 to 20 years ago – pulp mills have more recently
Developed into very clean operations. Their typical water demand has fallen from
more than 50 m3 t–1 pulp to below 30 m3 t–1, while some mills operate with volumes
below 10 m3 t–1. However, at such low levels of water usage other problems
Such as scaling may become a serious threat to the operation. Although water saving
may lead to additional environmental emissions – perhaps via a higher
demand for bleaching chemicals or a higher energy input – sophisticated water
Environmental Aspects of Pulp Production
management and “kidneys” for the separation of nonprocess elements and pollutants
Become essential for such an operation.
New mills are typically erected based on the continuing development of technology,
and current terms used to describe the state of the art are “accepted modern
technology” (AMT) or “best available technology” (BAT). As new or “emerging”
technology will develop into “accepted technology” once its applicability is proven,
Pulping and bleaching technology cannot be described as established processes.
Indeed, all processes are undergoing continual development and further improvement.
10.3
Дата добавления: 2015-10-21; просмотров: 112 | Нарушение авторских прав
<== предыдущая страница | | | следующая страница ==> |
Oxide as an alkalization source for the peroxide stage. This permitted | | | Emissions to the Atmosphere |