The polarizing film helps to get a better projected image.
1) Clean the windshield before applying the film. Determine where to put it and wet that section so that you can move the film easily to get the correct position.
2) Peel the protective film off the side marked Ў°BackЎ±, and then apply the film to windshield gently. Move it to the exact position. If needed, use a credit card to squeeze out bubbles and make it flat.
3) Finally peel off the protection film marked Ў°FrontЎ±.
D. How to use the Anti-slip mat
Put it in the correct position on the carЎЇs dash and then put the HUD on it.
E. How to layout the OBD connection cable better
If the OBD connection cable is too long, you can roll it up on the light control pole as follows:
Parts and Functions
OBD port 1/ 2 ЈєEither port can be used. Use the one that works best for the connection cable.
Light sensor Јє Display brightness is adjusted automatically by the ambient light sensor.
Power on/off Јє Turn the HUD on or off.
Dial button Јє Push the dial button forward, vertically-downward or backward to configure the HUD.
Key Overview
To ensure simple operation, the HUD has only two buttons, Power on/off and the Dial button.
l Power On/Off: Slide it to turn the HUD on or off.
l Dial Button: You can push it in three directions (forward, downward (vertically), and backward).
l The remote control has four buttons. They are Forward, Backward, OK, and Back. Their functions are the same as those of the dial button. During setup push the back button to back to working status.
1) In working mode push the Dial Button forward to switch the display mode (in a loop) within section A. The items are time, current running time, fuel consumption per 1km/1mile, engine rotation speed, etc. One push moves it one item.
2) In working mode push the Dial Button backward to switch the display mode (in a loop) within section B. The items are current speed, battery voltage, water temperature, the current mileage, etc. One push moves it one item.
3) In setup mode push the button down to switch among engine displacement, unit, over-speed warning, current time, value for water temperature warning, value for battery low voltage warning, time for tired driving notice, rotation speed for gear shift, the maximum speed for gear shift, fuel consumption calibration, speed calibration, whether to diagnose failure, scan failure, etc. Under each setup item, you can push the button forward to increase the value and backward to decrease the value, and vertically-downward to confirm the setup.
Дата добавления: 2015-10-29; просмотров: 102 | Нарушение авторских прав
| <== предыдущая страница | | | следующая страница ==> |
| B. Where to put the HUD in the car | | | Function Introduction |