Quick Start

If you are like me, you’ve already been playing with Evolver for a while, and later decided to check the manual. If not, here’s the standard short manual to get started.

First, plug in the power supply. If you need to use one of the alternate AC prongs, first remove the installed prongs by pushing the button and sliding off the prongs. Then slide on the desired prongs, and you’re ready to go.

Next, plug Evolver’s signal outputs to your mixer/sound system.

Hit the START button in the lower left corner to play a sequence. Listen to other Programs by turning the Program knob (top Main LED must be on), and keep the sequencer running if you want. When shipped, Bank 1 has sequencer-oriented Programs in locations 1 through 69. A complete description of Evolver’s 512 Programs can be found in the Program Notes section following.

You can play around with the sounds of the current Program by simply selecting a parameter in the programming matrix. Example — hit the button to select the third row, and grab knob 1 to adjust the Filter Cutoff Frequency. Note that you can access eight knobs in the selected row for fast tweaking. To get to the second (lower) set of parameters in any row, simply hold the SHIFT button down while turning the knob.

To edit the sequence steps, hit the SEQUENCER button. The programming matrix now changes to sequencer mode to adjust the 16 x 4 sequencer. Row 1 controls steps 1-8 and row 2 steps 9-16 for Sequence 1. Likewise rows 3 and 4 control sequence 2, etc. The SHIFT button has no effect in sequence mode.

Дата добавления: 2015-08-20