Activate Ring Modulation by pressing the RING MOD/SYNC button until the RING MOD LED is lit. This is a function (also known as amplitude modulation), where the waveforms of the two oscillators are multiplied. The result is a inharmonic sound, that is great for metallic or bell-like timbres.
When trying out Ring Modulation, make sure you listen to Oscillator 2, since it is mainly this that is affected by the timbre changes!
Turning the Oscillator 2 SEMITONES knob will change the timbre, much as with FM. However, with Ring Modulation, this will also affect the pitch of the sound! This means that activating Ring Modulation may result in a sound with a completely different pitch than the “normal” sounds. To remedy this, you should use the Ring Mod TUNE knob:
When Ring Modulation is activated, the FM Amount knob works as a Tune knob with a range of roughly one octave. To set the pitch to “normal”, turn off Ring Modulation and play a note, then activate Ring Modulation, play the same note and adjust the Tune knob until the pitch is the same. Please note that the pitch will change again if you change the timbre by adjusting the Semitones knob.
When Ring Modulation is activated, you cannot manually control the FM Amount, since that knob serves as a Tune knob. Instead you can use the Modulation Wheel, with its destination set to FM.
Это означает, что изменение высоты тона осциллятора 2 в принципе не затрагивает высоту тона звука, но тембр. Ручка FM AMOUNT управляет объёмом FM от осциллятора 2 к осциллятору 1.
Для классических FM звуков, используйте SINE на осцилляторе 1 и TRIAGLE на осцилляторе 2.
Модуляция объёма FM
Обратите внимание, что объём FM можно модулировать от Mod Env и LFO 1, а также управлять вручную колесом модуляции.
Дата добавления: 2015-08-20; просмотров: 50 | Нарушение авторских прав
| <== предыдущая страница | | | следующая страница ==> |
| KBD Track | | | Кольцевая модуляция |