Студопедия
Случайная страница | ТОМ-1 | ТОМ-2 | ТОМ-3
АрхитектураБиологияГеографияДругоеИностранные языки
ИнформатикаИсторияКультураЛитератураМатематика
МедицинаМеханикаОбразованиеОхрана трудаПедагогика
ПолитикаПравоПрограммированиеПсихологияРелигия
СоциологияСпортСтроительствоФизикаФилософия
ФинансыХимияЭкологияЭкономикаЭлектроника

Brake fluid level and leaks

INSPECTION AFTER INSTALLATION | ENGINE MAINTENANCE (MR18DE) | When draining all of engine coolant in the system, open I | AIR CLEANER FILTER | Be sure to clean drain plug (2) and install with new washer. | Never drop or shock it. | REPLACEMENT PROCEDURES | Always use lint free paper towels to wipe fluid off the CVT fluid level gauge. | SEAT BELT, BUCKLES, RETRACTORS, ANCHORS AND ADJUSTERS |


Читайте также:
  1. All Words, Level 3 teens
  2. Always use lint free paper towels to wipe fluid off the CVT fluid level gauge.
  3. Approaches to English teaching at primary level
  4. Are you ready for the level?
  5. B) Understand high-level business requirements
  6. B: item, manufacturer, to refer to, level, a lot of, wish, constant, product mix, to use, guarantee.
  7. Basic level of knowledge and skills

 

SMA829C


BRAKE FLUID LEVEL AND LEAKS: On Board Inspection INFOID:0000000004683839

 

CHECKING BRAKE FLUID LEVEL

Make sure the fluid level in the reservoir tank is within the standard (between MAX and MIN lines).

• Visually check around the reservoir tank for fluid leaks.

• If fluid level is excessively low, check brake system for fluid leaks.

• Release parking brake lever and see if brake warning lamp goes off. If not, check brake system for fluid leaks.

 

SFIA3067E

 

BRAKE FLUID LEVEL AND LEAKS: Drain and Refill INFOID:0000000004683840

CAUTION:

Refill using recommended brake fluid. Refer to MA-14, "Fluids and Lubricants".

Never reuse drained brake fluid.

Be careful not to splash brake fluid on painted areas; it may cause paint damage. If brake fluid is splashed on painted areas, immediately wipe them with cloth and wash it away with water.

Before working, disconnect connectors of ABS actuator and electric unit (control unit) or battery negative terminal.

1. Connect a vinyl tube to bleed valve.

2. Depress the brake pedal, loosen the bleed valve, and gradually remove the brake fluid.

 

 

WFIA0512E

 


Revision: October 2008


MA-46


2009 Versa


3. Clean inside of reservoir tank, and refill with new brake fluid.

4. Loosen bleed valve, depress brake pedal slowly to full stroke A

and then release it. Repeat the procedure every 2 or 3 seconds until the new brake fluid comes out, then close the bleed valve

while depressing the brake pedal. Repeat the same procedure B

for each wheel.

 

5. Bleed the air from the brake hydraulic system. Refer to BR-9,

"Bleeding Brake System". C

 



Дата добавления: 2015-11-16; просмотров: 56 | Нарушение авторских прав


<== предыдущая страница | следующая страница ==>
Do not overfill.| BRAKE LINES AND CABLES

mybiblioteka.su - 2015-2024 год. (0.005 сек.)