Студопедия
Случайная страница | ТОМ-1 | ТОМ-2 | ТОМ-3
АвтомобилиАстрономияБиологияГеографияДом и садДругие языкиДругоеИнформатика
ИсторияКультураЛитератураЛогикаМатематикаМедицинаМеталлургияМеханика
ОбразованиеОхрана трудаПедагогикаПолитикаПравоПсихологияРелигияРиторика
СоциологияСпортСтроительствоТехнологияТуризмФизикаФилософияФинансы
ХимияЧерчениеЭкологияЭкономикаЭлектроника

By the transmission electron microscopy (TEM) surface replica technique

Читайте также:
  1. Electronic Commerce
  2. Electronic money
  3. Electronics
  4. Literary techniques
  5. Microscopy
  6. One pint of used oil can cover one acre of water surface and kill sensitive marinecreatures. . .

described by Purz et al. [64] and by Fink et al. [53]. A characteristic micrograph of

Eucalyptus sulfite dissolving pulp is shown in Fig. 11.21a, with the primary wall

Having been largely removed. The morphological architecture of the sulfite pulp is

Clearly dominated by the S1 layer (Fig. 11.21a).

Identification of the cell wall layers is possible by the preferred orientation of

The exposed cellulose microfibrils with respect to the cell axis. The latter is indicated

By arrows in the micrographs.

On the other hand, residues of the primary wall can be detected for the PHK

viscose pulp (low P-factor) (Fig. 11.21b, top). Apparently, the type of pulp – as well

as process conditions during pulp manufacture – exert an influence on the exposure

S1

Fig. 11.21 Transmission electron microscopic surface replica of

(a) eucalypt sulfite dissolving pulp (b) eucalyptus PHK pulp

(c) eucalyptus PHK pulp with high P-factor [56].

S1

PW

S1

Pulp Properties and Applications

Of cell wall layers. Clearly, mild prehydrolysis combined with alkaline cooking is

Less detrimental to cellulose microfibrils than acid sulfite cooking, thus leaving

The primary cell wall morphology largely unaffected. However, PHK cooking,

Using intensified prehydrolysis conditions to produce pulps of very low residual

Hemicellulose content (e.g., xylan), further removes the primary cell wall layers, as

Shown in Fig. 11.21c. Therefore, the microfibrillar structure of this PHK pulp

(high P-factor) is almost comparable to that of the sulfite pulps.

The different behavior of the three dissolving pulps with regard to lattice transition

As a function of NaOH concentration can be explained by their different morphological

Structure. It is interesting to note that the supramolecular structure

May be influenced by the cell wall structure of the dissolving pulps. Also, the

Markedly higher reactivity of sulfite and highly purified PHK pulps in ageing of

Alkali cellulose and xanthation may well be caused by a weakening of the outer

Layers of the wood fiber cell wall due to the higher hydrolytic action during final

Phase sulfite cooking and intensified prehydrolysis.

Distribution of Hemicelluloses across the Fiber Wall

In the manufacture of dissolving pulps, the objective is to remove as much hemicelluloses

As possible without causing too-severe cellulose deterioration. An

Important topic with regard to further process development is how the remaining

Hemicelluloses are located within the fiber wall. The different chemistry of acid


Дата добавления: 2015-10-21; просмотров: 96 | Нарушение авторских прав


Читайте в этой же книге: The residual lignin is not only a concern for optical properties, but also governs | The numerical evaluation of the MWD, as well as additional pulp quality parameters, | Results depicted in Fig. 11.7 clearly confirm the relationship between the maximum | Reactions under strongly alkaline conditions. | Provided that the ozone treatment is followed by an alkaline treatment. | Endgroups from the total amount of carbonyls | Pulp Properties and Applications | And intensive ozone bleaching as well as reinforced hot caustic | The transformation to Na-cellulose I begins at a NaOH concentration of about | Low Viscosity, Low Purity Low Viscosity, High Purity |
<== предыдущая страница | следующая страница ==>
Reactivity towards acetylation changes only marginally. This may be explained by| Sulfite and alkaline cooking procedures, as well as the heterogeneous distribution

mybiblioteka.su - 2015-2024 год. (0.007 сек.)