Студопедия
Случайная страница | ТОМ-1 | ТОМ-2 | ТОМ-3
АвтомобилиАстрономияБиологияГеографияДом и садДругие языкиДругоеИнформатика
ИсторияКультураЛитератураЛогикаМатематикаМедицинаМеталлургияМеханика
ОбразованиеОхрана трудаПедагогикаПолитикаПравоПсихологияРелигияРиторика
СоциологияСпортСтроительствоТехнологияТуризмФизикаФилософияФинансы
ХимияЧерчениеЭкологияЭкономикаЭлектроника

Washing. The pulp entering the CCE stage must be thoroughly washed and

Читайте также:
  1. Fill in the blanks using the following words: balcony, stage, rows, pit, boxes, orchestra, stalls, gallery, orchestra stalls, rises, goes, down, curtain.
  2. Large amounts may be generated in the primary and secondary treatment stages.
  3. Medium as it rotates submerged in slurry, is then washed and continuously
  4. Multi-Stage Washing
  5. Open and Closed Operation of Bleaching Stages
  6. Oxide as an alkalization source for the peroxide stage. This permitted
  7. Parameters Units First stage Second stage

dewatered to a high consistency (>35%) in order to avoid dilution of the added

Caustic solution through the pulp slurry. The conditions of CCE include the

homogeneous distribution of pulp in 5–10% NaOH for at least 10 min at temperatures

between 25 and 45 °C in a downflow, unpressurized tower. Due to the rapid

Interaction between alkali and cellulose, a separate retention tower is not really

Needed (in industrial praxis, a tower would perfectly act as a surge tank). Removal

Of the lye from the highly swollen pulp is rather difficult, and requires efficient

post-CCE washing in a series of more than three washers [27]. Special attention

Must be paid to the washing concept in order to avoid reprecipitation of dissolved

Polymeric hemicelluloses (beta-cellulose) during the course of washing.

The most important parameters influencing the degree of purification are presented

In the following section.

8.3.1

NaOHC oncentration

As anticipated, the hemicellulose content in the pulp, determined as xylan,

Decreases linearly with increasing NaOH concentration in the aqueous phase of

the pulp suspension, up to a value of about 100 g L–1 (Fig. 8.5).

Parallel to the decrease in residual xylan content, an increase in R18 content

Can be observed. The course of R18 content during CCE treatment as a function

Of NaOH concentration is illustrated graphically in Fig. 8.6.

The purification efficiency of both sulfite and PHK pulps is quite comparable,

Provided that the initial xylan contents are at the same level. The xylan content of

The unbleached sulfite pulp was reduced by a mild hot caustic extraction followed

by oxygen delignification without interstage washing ((E/O)-stage). Purification

during CCE proceeds for both pulps to levels close to 1% xylan (or slightly below),

even at NaOH concentrations significantly lower than 100 g L–1, which prevents

The conversion of significant parts to Na-cellulose I (see Fig. 8.4). A subsequent

Change of the crystalline lattice to the cellulose II-type alters the fiber structure

and thus deteriorates pulp reactivity towards acetylation [29]. A xylan content of about

In the untreated pulp must be ensured in order to avoid a change in the supramolecular

Structure while attaining a sufficiently low xylan content to meet the required

Specifications for high-purity pulps (see Section 11.3, Tab. 11.7, Pulp properties).

The relationship between initial pulp purity (R18) and final xylan content

Cold Caustic Extraction

0 20 40 60 80 100

unbleached HW-S (E/O) treated HW-S O-Z treated E-PHK

Xylan content [%]

NaOH concentration [g/l]


Дата добавления: 2015-10-21; просмотров: 105 | Нарушение авторских прав


Читайте в этой же книге: Section 7.9 | Hemicelluloses), and the change of the molecular distribution to a narrow, | Temperatures. This explains why the alkali consumption does not correspond | The principal means of producing highly purified dissolving pulp. When applying | Concentrations, using X-ray diffraction. Ranby studied the appearance of cellulose | Appears to be alkali-resistant), the NaOH concentration must be increased from | This explains the different pattern of hemicelluloses removal as compared | During alkalization of a beech sulfite dissolving | Content is almost negligible. Therefore, the main objective of the alkali | Increase equally affects purification, as would a decrease in NaOH concentration |
<== предыдущая страница | следующая страница ==>
Lattice planes is widened from the original 0.61 nm to more than 1.2 nm due| Fig. 8.5 Purification of hardwood sulfite pulps

mybiblioteka.su - 2015-2024 год. (0.005 сек.)